How To Make A Hitching Post
The historic period-former hitching mail: a construction that aids in vet visits, baths, and saddling and increases the efficiency and usability of horse properties. Simply, despite their functionality and widespread utilise, not every hobby farm has one installed. Upgrade your farm with these quick-and-easy DIY instructions.
We asked Tory Shaffer, possessor of Colorado-based Shaffer Fencing, to share his expert advice on how to build an four x eight-foot hitching postal service in a unmarried weekend. Let's dig in.
Gather Supplies:The key to a durable hitching post is gathering the right supplies. You'll want:
- Subcompact tractor
- Post hole digger zipper (with ix-inch auger)
- Iii 8-foot, four-inch cedar posts: two to deed every bit legs, one to act as the track
- Four lxxx lb. bags of concrete mix
- Rubber mats
- Drill with six-inch drill scrap
- Wheelbarrow
- Tape measure
- Iv-foot Level
- Piece of work gloves
- Friends
- Mail-DIY beer
Pick and Level Location:Select a location near the front end of your barn, preferably near the tack room and water spigot, as you'll want piece of cake access to both your horse's tack and a h2o supply. Adhere a scraper to your subcompact tractor and level an approximately 10 ten x surface area of ground and so it'south flat and easily drainable.
Dig Holes:Dig two post holes four feet deep, and ix-inches wide. Infinite them vii feet apart so the top rail will overhang by six inches on either side. Use your tape measure to confirm each pigsty is four feet deep for maximum rigidity and stability.
Prepare First Batch of Concrete:Mix ii numberless of concentrate with h2o in your wheelbarrow. The ideal texture is moisture but not sloppy. Recall: putty; not soup.
Install First Post:Identify the get-go post in the freshly dug hole. Use the level to ensure the mail is plumb. (Read: straight upwards and downwardly.) Have your friend hold it steady for you, as you cascade in the concrete mix. Hold the post for x seconds while the physical sets. Later on, you can refill in remaining space with dirt.
Repeat: mix some other batch of concentrate and install the second post.
Install the Top Runway:Identify the top piece of cedar atop the ii posts, leaving six inches of overhang on either side. Then use your level to ensure the posts are of equal elevation. If they're not, adjust the axle until its level, and so mark the higher post with where to cut it. Lob off the backlog superlative so the 2 posts are level. Then, drill airplane pilot holes with the drill flake. Utilize a half-dozen-inch drill flake and half-dozen-inch lag bolt to drill the lag bolt into the wood to secure the rail to the post. Finish with an anti-chew spray in case your horses are chewers.
Accessorize:Add together extra usability to your fencing postal service with rubber mats, concentrate or pea gravel. Shaffer recommends prophylactic mats for added rubber and usability during baths. Information technology keeps the area from getting too muddy.
Celebrate:Crevice open a beer and hitch your horse upward. Yous're done.
Source: https://stablemanagement.com/articles/ultimate-hitching-post/
0 Response to "How To Make A Hitching Post"
Post a Comment